Bit Switches - 2; I-Fax Switches - Ricoh Type M12 Field Service Manual

4. Service Tables

Bit Switches - 2

• Do not adjust a bit switch or use a setting that is described as "Not used", as this may cause the
machine to malfunction or to operate in a manner that is not accepted by local regulations. Such
bits are for use only in other areas, such as Japan.
Default settings for bit switches are not listed in this manual. Refer to the System Parameter List printed by
the machine.

I-Fax Switches

No
Original Width of TX Attachment File
0 A4
1 B4
2 A3
3-6 Reserved
7 Not used
0: Off (not selected), 1: On (selected)
If more than one of these three bits is set to "1", the larger size has priority. For example, if
both Bit 2 and Bit 1 are set to "1" then the maximum size is "A3" (Bit 2).
When mail is sent, there is no negotiation with the receiving machine at the destination, so the
sending machine cannot make a selection for the receiving capabilities (original width
setting) of the receiving machine. The original width selected with this switch is used as the RX
machine's original width setting, and the original is reduced to this size before sending. The
default is A4.
If the width selected with this switch is higher than the receiving machine can accept, the
machine detects this and this causes an error.
108
I-fax Switch 00 (SP No. 1-102-001)
Function
This setting sets the maximum size of the original that
the destination can receive. (Bits 3 to 6 are reserved
for future use or not used.)
-
I-fax Switch 01 (SP No. 1-102-002)
Comments