Table of Contents
Advertisement
4. Operating the Stove
This wood heater has a manufacturer-set minimum low burn rate that must not be
altered. It is against federal regulations to alter this setting or otherwise operate this
wood heater in a manner inconsistent with operating instructions in this manual.
Before using the stove, the following steps should be completed :
• Install the pedestal or the leg kit (see
Installation»)
• Install the door overlay (see
• Install the ash lip pan.
Figure 13: Installing the ash lip pan
The following steps are optional :
• Install the blower (see
• Install the fresh air intake (see
• Install the ash lip glass panel.
4.1
The Use of a Fire Screen
This stove has been tested for use with an open door in conjunction with a fire screen, sold
separately. The fire screen must be properly secured on the stove to avoid any risk of sparks
damaging the flooring. When the fire screen is in use, do not leave the stove unattended to
respond promptly in the event of smoke spillage into the room. Potential causes of smoke
spillage are described in Section
Optional Fire Screen Installation»
OPERATING THE STOVE WITH A FIRE SCREEN INCREASES POSSIBILITIES OF
GENERATING CARBON MONOXIDE. CARBON MONOXIDE IS AN ODOURLESS GAS THAT
IS HIGHLY TOXIC WHICH CAN CAUSE DEATH AT HIGH CONCENTRATION IN AIR.
Page 18
«Appendix 1: Legs
«Appendix 3: Door Overlay
«Appendix 7: Optional Blower and Thermodisc
«Appendix 5: Optional Fresh Air Intake Kit Installation»)
«9. The Venting System»
for installation instructions.
Installation», or
«Appendix 2: Pedestal
Installation»),
Figure 14: Optional ash lip glass panel
Installation»)
of this manual. See
Installation and Operation Manual - 1700
«Appendix 6:
Hide quick links:
Advertisement
Table of Contents
