Door - Osburn Beyond Fire 1700 Installation And Operation Manual

To remove or replace the glass (D):
1. Remove the door (E) from its hinges and lay it on a
soft, flat surface.
2. Remove the eight screws (A), the eight glass
retainers (B), and the metal frames (C).
Remove the glass (D). If it is damaged install a new
3.
one in place. The replacement glass must have a
gasket all around (see procedure below).
4. Reinstall the glass, being careful to centre the glass
in the door and not to over-tightening the retaining
screw.
The two main causes of broken door glass are
uneven placement in the door and over-tightening
the retaining screws.
6.2.3 Gasket
The glass gasket is flat, adhesive-backed, woven fibreglass. The gasket must be centred on the
edge of the glass.
5. Peel off more of the backing and rotate the glass. The gasket must not be stretched during
installation.
6. Cut the gasket to the required length.
7. Pinch the gasket onto the glass in a U-shape, all around the glass.
6.3

Door

In order for the stove to burn at its best efficiency, the door
must provide a perfect seal with the firebox. The tightness
of the door seal can be verified by closing and latching
the door on a strip of paper. The test must be performed
all around the door. If the paper slips out easily anywhere,
either adjust the door or replace the gasket.
Page 26
1. Follow the steps of the previous section to remove the glass.
2. Remove the old gasket and clean the glass thoroughly.
3. Peel back a section of the paper covering the adhesive and place
the gasket on a table with the adhesive side up.
4. Stick the end of the gasket to the middle of one edge, then press
the edge of the glass down onto the gasket, taking care that it is
perfectly centred on the gasket.
C
D
E
Installation and Operation Manual - 1700
A
B