Omron EQUO Series User Manual page 7

Observe the following precautions to ensure safe operation:
Air Flow Station
・ Do not install the product in the places subject to exposure to water, oil, or chemical splashes.
・ Do not use the product for the safety circuits in nuclear power or life-critical applications.
・ When disposing of the product, treat as industrial waste.
・ Do not let the product drop or subject it to a shock, which may cause its damage or malfunction. Use
screws to secure the product when mounting it on the wall. Stop using the product if it has been applied
with a strong impact.
・ When inserting or removing an SD memory card, securely hold the product to prevent it from dropping,
which may cause a damage. Do the same when inserting or detaching an alarm output cable or
connector.
・ Do not bring the product close to magnetic products (e.g. magnetic cards), sensitive electronics
equipment (e.g. computers or clocks), when the product is attached with the mounting magnets.
・ Small pieces may be chipped off the mounting magnets when they are attracted to the surface. Make
sure the pieces do not enter the eyes. Consult a medical doctor if this happens.
・ When using the mounting magnets to install the product, take caution not to allow a finger to be caught
between the product(s) and the magnetic surface.
・ Do not install the product at a high place when using the mounting magnets.
・ Apply an appropriate load to the alarm output terminals to prevent possible smoking.
・ If liquid crystal leaks due to a damage to the LCD panel, take caution not to allow it to contact your skin,
to be inhaled or swallowed. If it has contacted your skin or entered your mouth, seek medical attention.
・ Take anti-static electricity measures (e.g. touching grounded metal object) when handling the product.
Air Flow Sensor (D6FZ-Series)
<D6FZ-Series>
・ Do not use the power supply that exceeds rated voltage.
・ Use a DC power supply unit provided with anti-voltage design (safety extra low voltage circuit) to supply
power to the product.
・ Do not connect the power supply in reverse.
・ Do not short-circuit outputs.
・ The attached connection cable is only for Air Flow Station (D6FZ-FGX). Do not connect with other
device.
・ Do not use the Sensor with any gases or liquids other than specified in this document.
・ Be sure to secure the Sensor with the stipulated torque.
・ Do not install the Sensor in a location where strong compressive force or tensile force applied to the
Sensor.
・ Do not attempt to disassemble, repair, or modify this product.
・ When disposing of the product, treat as industrial waste.
Precautions for Safe Use
vi