AXIOMTEK tBOX320-852-FL Series User Manual page 3

Safety Precautions
Before getting started, please read the following important safety
precautions.
1. User should not modify any unmentioned jumper setting
without Axiomtek FAE's instruction. Any modification without
instruction might cause system to become damage
2. The tBOX320-852-FL does not come equipped with an
operating system. An operating system must be loaded first
before installing any software into the computer.
3. Be sure to ground yourself to prevent static charge when
installing the internal components. Use a grounding wrist
strap and place all electronic components in any static-
shielded devices. Most electronic components are sensitive
to static electrical charge.
4. Disconnect the power cord from the tBOX320-852-FL before
making any installation. Be sure both the system and the
external devices are turned OFF. Sudden surge of power
could ruin sensitive components. Make sure the tBOX320-
852-FL is properly grounded.
5. Make sure the voltage of the power source is correct before
connecting the equipment to the power outlet.
6. Turn OFF the system power before cleaning. Clean the
system using a cloth only. Do not spray any liquid cleaner
directly onto the screen.
7. Do not leave this equipment in an uncontrolled environment
where the storage temperature is below -30℃ or above 80℃.
It may damage the equipment.
Do not open the system's back cover. If opening the cover for
8.
maintenance is a must, only a trained technician is allowed to
do so. Integrated circuits on computer boards are sensitive to
static electricity. To avoid damaging chips from electrostatic
discharge, observe the following precautions:
 Before handling a board or integrated circuit, touch an
unpainted portion of the system unit chassis for a few
seconds. This will help to discharge any static electricity
on your body.
 When handling boards and components, wear a wrist-
grounding
component stores.
strap, available from most electronic
iii