Table of Contents
Advertisement
1 Safety instructions
1.1 Environment conditions
Please install the equipment according to the following conditions for safe operations.
(1)Please install the equipment indoors according to following conditions:
．Ambient temperature range (-10～+40℃)
．Relative humidity range: 30～85%
． Altitude: less than1000m
． Make indoor clean and vented.
． Ensure the equipment far away from the corrosive gas, inflammable and explosive gas as
well as steamy wet environment.
(2)Power source: 220v/1ph/50Hz and 380v/3ph/50Hz, or refer to the nameplate; Compressed air
pressure≧0.6Mpa.
(3)To facilitate use, operation, maintenance and inspection of the machine, adequate clearances around it
shall be required.
The scaled diagram for installation, please refer to Fig.4-6
(4) Please place the equipment level.
(5)The vibration by other complicated environmental conditions may not exceed12 mm· s
1.2 Description of warning signs
(1)In order to well understand this operation Manual, the safety warning signs are classified as following.
(2)These warning signs have been set up according to the operating regulations and safety precautions
for the equipment. In order to avoid dangerous accidents, this Operation Manual also includes detailed
preventions. Please operate the equipment according to the instructions based on sufficient
understanding of warning signs.
Table1-1Description of warning signs
This sign warns: In order to avoid death and serious injury
accidents, please be sure to operate the equipment according to
relevant stipulations of safety instructions.
This sign warns: In order to avoid potential dangerous accidents
and serious injuries, please operate the equipment according to
relevant stipulations of safety instructions.
This sign warns: In order to avoid minor and potential moderate
injuries, please operate the equipment according to relevant
stipulations of safety instructions.
1
-1
.
Advertisement
Table of Contents
