Famsun Muyang SJPS215 Operation Manual page 61

Fig.5-2 on touch screen.
 Switch water and steam to "automatic" mode on the image of "liquid application" (of extruder barrels)
in Fig.5-3 on touch screen.
【Note】:
①The default mode of touch screen after startup is "manual". After it is switched to automatic, the touch
screen is off. When re-start is called for after the touch screen is off, the mode re-switch from manual to
automatic is required.
② Auto material feeding, auto water to conditioner, auto water to extruder barrel, and auto steam to
extruder barrel are independent from each other to allow users to choose the mode of partly automatic
and partly manual.
Fig.5-2 Liquid application (conditioner)
Fig.5-3 Liquid application (extruder barrel)

Preset parameters: set the "set capacity" on the "parameter" image in Fig.5-4 for the throughput of
extrusion system. At the same time, set the following parameters on the " important parameter" image as
Fig.5-5:
 Water SP% value of conditioner (percentage of throughput);
56