Steam SP% value of conditioner (percentage of throughput);
Steam SP% value of extruder barrel (percentage of throughput); (as needed according to actual
demand)
Steam SP% value of extruder barrel (percentage of throughput); (as needed according to actual
demand)
Fig.5-4 Parameter setting
Fig.5-5 Important parameters
Switch "AUTO, TEST and MANU" at the upper right corner to "AUTO" mode on "production process"
image in Fig.5-1; press "Start" to start up the equipment. And then, the control system excutes the
following commands in sequence:
Confirm the conditioner outlet is at the bypass;
Conditioner motor starts at star-delta;
Pneumatic gate on the feeding bin automatically opens to allow feeding to the bin. When material
57