Table of Contents
Advertisement
Figure 11. Camera Link Module Accessory Kit
Camera Link Installation
The Camera Link Module plugs into the Hirose connector on the back of the Tau SWIR camera, as shown
in.Figure 10. Prior to installing the two M1.6 x 0.35 x 20mm screws, the two mini spacers must be
slipped in between the module and the back cover of the camera, as shown in Figure 12.
Figure 12. Camera Link Module Installation
Plug the TEC cable into the TEC power connector on the side of the camera, ensureing the locking
mechanism engages. Install the TEC power cover plate using the supplied screws. If, for any reason, the
TEC power connector must be removed, the Molex Pico-Lock connector must be pinched on both ends to
disengagy the locking mechanism. Once unlocked, gently pull out and slightly forward (toward the front
of the camera), ensuring the connector does not get hung up on the camera body. Apply the minimum
force necessary to remove the cable from the connector. Use caution as to not pull the wires out of the
connector body.
Page 20
The information contained in this document pertains to a dual use product controlled for export by the Export Administration
Regulations (EAR). Diversion contrary to US law is prohibited. US Department of Commerce authorization is not required prior to
export or transfer to foreign persons or parties unless otherwise prohibited.
Advertisement
Table of Contents
