Setup; Camera; Conditions - FLIR SyncroIP Series Software Manual

Web Configuration Interface

Setup

The Setup menus allow you to configure camera settings.

Camera

Conditions

The Conditions menu allows you to configure the image sensor settings for the camera. As you
make adjustments, the effects will be shown in the video display.
NOTE: Some settings described below may not be available, depending on the features of your
camera model.
To configure the image sensor settings:
1. Configure the following:
• Profile: Select the camera settings profile you would like to configure: Day, Night, or Normal.
• Brightness: Adjust the brightness of the image between 0 and 100.
• Contrast: Adjust the contrast of the image between 0 and 100.
• Saturation: Adjust the color saturation of the image between 0 and 100.
• Sharpness: Adjust the sharpness of the image between 0 and 100. Higher sharpness will
make edges in the image clearer, but may increase noise in the picture.
• Anti-flicker: Select the anti-flicker mode depending on the environment:
• Outdoor: The system will use the exposure mode to adjust for lighting.
• 50Hz: The system will compensate for lighting using 50Hz AC power (i.e. for Europe).
• 60Hz: The system will compensate for lighting using 60Hz AC power (i.e. for North
America).
• Exposure: Select the exposure mode.
• Auto: The system will automatically adjust the brightness and exposure based on the
environment.
• Low Noise: The system will automatically adjust the gain to reduce the amount of noise
in the image. Set the minimum and maximum Gain Scope. Increasing the max gain will
increase the noise reduction.
9