Chrysler 300M 2002 Service Manual page 1535

23 - 96 SEATS
REAR SEAT CUSHION COVER (Continued)
Fig. 43 REAR SEAT CUSHION COVER HOG RING
1 - HOG RINGS
(5) Install seat cushion (Refer to 23 - BODY/
SEATS/SEAT CUSHION REAR - INSTALLATION).
SEAT ADJUSTERS
REMOVAL - AIRBAG EQUIPPED
WARNING: DISCONNECT AND ISOLATE THE NEGA-
TIVE BATTERY CABLE
BEFORE BEGINNING ANY FRONT SEAT REMOVAL
OR INSTALLATION PROCEDURE. THIS WILL DIS-
ABLE THE AIRBAG SYSTEM. FAILURE TO DISCON-
NECT THE BATTERY
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSI-
BLE PERSONAL INJURY.
WARNING: ONCE THE NEGATIVE CABLE IS DIS-
CONNECTED WAIT FOR 2 MINUTES BEFORE
REMOVING ANY AIRBAG SYSTEM COMPONENTS.
(1) Disconnect and isolate the remote negative bat-
tery cable.
REMOTE TERMINAL
COULD RESULT
(2) Remove the front seat back. Refer to the proce-
dure in this group.
(3) Remove bolts attaching seat adjuster to cush-
ion pan (Fig. 44).
(4) Disconnect wire harness from cushion pan.
(5) Remove seat adjuster from seat cushion.
Fig. 44 FRONT SEAT TRACK - TYPICAL
1 - ATTACHING BOLTS
INSTALLATION - AIRBAG EQUIPPED
(1) Place seat adjuster in position on seat cushion
pan.
IN
(2) Connect wire harness to the cushion pan.
(3) Install bolts attaching seat adjuster to cushion
pad.
(4) Install seat back. Refer to the procedure in this
group.
(5) Install bolt to attach seat back recliner to seat
back on each side of seat. Tighten bolt to 8 N·m (71
in. lbs.) torque.
(6) Connect the negative battery cable.
(7) Using the DRB III Scan Tool erase all DTC's
and perform airbag system diagnostics.
LH