Chrysler 300M 2002 Service Manual page 1512

LH
REAR VIEW MIRROR (Continued)
(4) Apply accelerator to the surface on the bracket
according to the following instructions:
(a) Crush the vial to saturate the felt applicator.
(b) Remove the paper sleeve.
(c) Apply accelerator to the contact surface on
the bracket.
(d) Allow the accelerator to dry for five minutes.
(e) Do not touch the bracket contact surface
after the accelerator has been applied.
(5) Apply adhesive accelerator to the bracket con-
tact surface on the windshield glass. Allow the accel-
erator to dry for one minute. Do not touch the glass
contact surface after the accelerator has been
applied.
(6) Install the bracket according to the following
instructions:
(a) Apply one drop of adhesive at the center of
the bracket contact-surface on the windshield
glass.
(b) Apply an even coat of adhesive to the contact
surface on the bracket.
(c) Align the bracket with the marked position
on the windshield glass.
(d) Press and hold the bracket in place for at
least one minute.
NOTE: Verify that the mirror support bracket is cor-
rectly aligned, because the adhesive will cure rap-
idly.
(7) Allow the adhesive to cure for 8-10 minutes.
Remove any excess adhesive with an alcohol-damp-
ened cloth.
(8) Allow the adhesive to cure for an additional
8-10 minutes before installing the mirror.
REAR SEAT GRAB HANDLE/
READING LAMP
REMOVAL
(1) Pull down coat hook.
(2) Remove screw attaching assist handle to roof
from behind coat hook.
(3) Pull and hold assist handle down.
(4) Remove front screw attaching assist handle to
roof (Fig. 24).
(5) Remove assist handle from roof.
(6) Disengage clips attaching reading lamp socket
to back of assist handle base.
(7) Disconnect reading lamp switch from slot on
back of assist handle base.
(8) Remove assist handle from vehicle.
Fig. 24 REAR ASSIST HANDLE AND READING
1 - COAT HOOK
2 - ASSIST HANDLE
3 - HEADLINING
INSTALLATION
(1) Place assist handle in position on vehicle.
(2) Connect reading lamp switch into slot on back
of assist handle base.
(3) Engage clips attaching reading lamp socket to
back of assist handle base.
(4) Place assist handle in position on roof.
(5) Pull and hold assist handle down.
(6) Install front screw attaching assist handle to
roof.
(7) Install screw behind coat hook attaching assist
handle to roof.
INTERIOR 23 - 73
LAMP