Chrysler 300M 2002 Service Manual page 1346

LH
FLUID (Continued)
Fig. 234 Fluid Level Indicator
1 - FLUID LEVEL INDICATOR
1 - MAX. LEVEL
2 - MIN. LEVEL
because it allows the pump to take in air along with
the fluid. As in any hydraulic system, air bubbles
make the fluid spongy, therefore, pressures will be
low and build up slowly.
high. When the transaxle has too much fluid, the
gears churn up foam and cause the same conditions
which occur with a low fluid level.
and/or fluid oxidation, and varnishing. This can
interfere with normal valve, clutch, and accumulator
operation. Foaming can also result in fluid escaping
from the transaxle vent where it may be mistaken
for a leak.
condition of the fluid. When the fluid smells burned,
and is contaminated with metal or friction material
particles, a complete transaxle recondition is needed.
Fig. 235 42LE Fluid Temperature Chart
Low fluid level can cause a variety of conditions
Improper filling can also raise the fluid level too
In either case, air bubbles can cause overheating
Along with fluid level, it is important to check the
TRANSAXLE 21 - 97