LH
SLAM BUMPER
REMOVAL
(1) Open decklid.
(2) Pull slam bumper from decklid.
(3) Remove slam bumper from decklid.
INSTALLATION
(1) Place slam bumper in position on decklid.
(2) Push slam bumper into decklid.
(3) Verify decklid alignment.
SUPPORT CYLINDER
REMOVAL
(1) Open decklid.
(2) Support decklid with a suitable prop device.
(3) Remove gas prop lock caps on each end (Fig. 9).
(4) Remove gas prop from vehicle.
INSTALLATION
(1) Place gas prop in position on vehicle.
(2) Install the lock caps on the gas prop.
(3) Verify decklid operation.
Fig. 9 DECKLID GAS PROP
1 - LOCK CAP
2 - DECKLID
3 - LOCK CAP
4 - GAS PROP
DECKLID 23 - 17