Chrysler 300M 2002 Service Manual page 1350

LH
GEAR SHIFT CABLE - COLUMN (Continued)
Fig. 241 Tilt Lever Screw Removal/Install
1 - STEERING WHEEL
2 - TURN SIGNAL LEVER
3 - TILT LEVER
4 - SCREWDRIVER
(6) Remove the ignition key and remove lower col-
umn cover (Fig. 242).
Fig. 242 Lower Column Cover Removal/Insta
1 - LOWER COLUMN COVER
(7) Remove cable from shift pin (Fig. 243).
(8) Remove cable retainer clip from shift cable con-
duit bracket (Fig. 243).
CAUTION: Column must be tilted fully upward to
remove cable retainer clip.
(9) Raise hood. From inside the engine compart-
ment, remove the gear shift cable from the cable
bracket (Fig. 244).
Fig. 243 Column Gear Shift Cable—Re
1 - CONDUIT BRACKET
2 - RETAINER CLIP
3 - GEARSHIFT CABLE
4 - SHIFT PIN
Fig. 244 Throttle/Gearshift Cable Bracket
1 - CABLE BRACKET
2 - GEARSHIFT CABLE
3 - THROTTLE CABLE
(10) Unseat the cable grommet from the firewall
(Fig. 246) and pull the shift cable from the interior of
the vehicle.
(11) Raise vehicle on hoist and unbolt fill tube
bracket. Rotate fill tube to gain access to the inte-
grated shift cable clamp.
(12) Disconnect cable from routing bracket as
shown in (Fig. 245).
TRANSAXLE 21 - 101