Chrysler 300M 2002 Service Manual page 1468

LH
DOOR GLASS (Continued)
(4) Tighten nuts to attach regulator roller channel
to glass and lift plate.
(5) Install upper trim retainer channel.
(6) Install watershield.
(7) Install door trim panel. (Refer to 23 - BODY/
DOORS - REAR/TRIM PANEL - INSTALLATION)
ADJUSTMENTS
ADJUSTMENT
(1) Remove door trim panel. (Refer to 23 - BODY/
DOORS - REAR/TRIM PANEL - REMOVAL)
(2) Remove watershield as necessary.
(3) Loosen fastener attaching scissor channel to
door panel at rear of access hole (Fig. 4).
(4) Position glass in run weatherstrips to achieve
smooth operation and proper fit.
(5) Push glass aft and apply slight downward pres-
sure on scissor channel and tighten screw.
(6) Tighten all fasteners.
(7) Install watershield.
(8) Install door trim panel.(Refer to 23 - BODY/
DOORS - REAR/TRIM PANEL - INSTALLATION)
Fig. 4 REAR DOOR GLASS ADJUSTMENT
1 - SCISSOR CHANNEL
2 - REAR DOOR
3 - DOOR GLASS ADJUSTMENT
HINGE
REMOVAL
(1) Mark outline of hinge on B-pillar and door end
frame.
(2) Remove nut and bolt attaching hinge to B-pil-
lar. Refer to Rear Door Removal procedure.
(3) Remove bolts attaching hinge to door end
frame (Fig. 5).
(4) Remove hinge from door.
Fig. 5 REAR DOOR HINGE
1 - B-PILLAR
2 - DOOR WIRE HARNESS CONNECTOR
3 - UPPER HINGE
4 - LOWER HINGE
5 - CHECK STRAP
INSTALLATION
(1) Align hinge to marks on door end frame.
(2) Place hinge in position on door.
(3) Install bolts attaching hinge to door end frame.
(4) Align hinge to marks on B-pillar.
(5) Install nut and bolt attaching hinge to B-pillar.
(6) Verify door alignment and operation, adjust as
necessary.
LATCH
REMOVAL
(1) Close door glass.
(2) Remove door trim panel.(Refer to 23 - BODY/
DOORS - REAR/TRIM PANEL - REMOVAL)
(3) Remove rear glass channel.
(4) Disconnect lock button link from door latch.
(5) Disconnect outside door handle link from door
latch.
(6) Remove screws attaching door latch to door end
frame (Fig. 6).
(7) Remove latch from door.
DOORS - REAR 23 - 29