Chrysler 300M 2002 Service Manual page 1474

LH
COWL GRILLE AND SCREEN
REMOVAL
(1) Release hood latch and open hood.
(2) Remove wiper arms. (Refer to 8 - ELECTRI-
CAL/WIPERS/WASHERS/WIPER
REMOVAL)
(3) Remove screws attaching cowl screen at the
windshield and under hood (Fig. 2).
(4) Remove cowl screen from vehicle.
Fig. 2 COWL SCREEN
1 - PLENUM COWL SCREEN
2 - COWL SCREEN RIGHT
3 - COWL SCREEN LEFT
INSTALLATION
(1) Place cowl screen in position on vehicle.
(2) Install cowl screen screws, starting at fender
moving inboard.
(3) Install wiper arms. (Refer to 8 - ELECTRICAL/
WIPERS/WASHERS/WIPER ARMS - INSTALLA-
TION)
EXTERIOR NAME PLATES
REMOVAL
REMOVAL - DOUBLE SIDED TAPE
ARMS -
(1) Mark reference points before removing.
(2) Using a heat gun gently apply heat in a circu-
lar motion to loosen the adhesive bond.
(3) Using a nonmetallic prying device, such as a
plastic or wood trim stick gently pry up at corners
and remove.
(4) Clean off all traces of adhesive or double sided
tape from the panel with a general purpose adhesive
remover.
REMOVAL - ADHESIVES
(1) Mark reference points before removing.
(2) Using a heat gun gently apply heat in a circu-
lar motion to loosen the adhesive bond.
(3) With your fingernail lift up and peel away
badgeing/tape from panel, using a heat gun as you
go.
(4) Clean off all traces of adhesive from the pan-
el(s) with a general purpose adhesive remover.
INSTALLATION
INSTALLATION - DOUBLE SIDED TAPE
(1) Clean panel surface with isopropy alcohol.
(2) Align badgeing to reference points.
(3) Install and press securely to full adhesive con-
tact
(4) Clean away any reference points.
INSTALLATION - ADHESIVES
(1) Clean panel surface with isopropy alcohol.
(2) Remove paper carrier and align badgeing/tape
to reference points or adjacent panel.
(3) Install and press securely, using a plastic
spreader to eliminate all air bubbles.
(4) Remove top protective carrier.
(5) Clean away any reference points.
EXTERIOR 23 - 35