Sony CDP-CX153 Operating Instructions Manual page 16

Playing CDs
6
Press ENTER.
The disc being programmed
DISC
2 0
The track being
programmed
7
To program other discs/tracks, do the following:
To program
Other discs
Other tracks on the same disc
Other tracks on other discs
8
Press ( to start Program Play.
To cancel Program Play
Press CONTINUE.
The programs remain even after Program Play ends
When you press (, you can play the same program
again.
When you press PROGRAM during Continuous or
Shuffle Play
The program you played last time appears and will be
played after the current track.
The programs remain until you erase them
If you replace discs, the programmed disc and track
numbers remain. So, the player plays only the existing
disc and track numbers. However, the disc and track
numbers that are not found in the player or on the disc
are deleted from the program, and the rest of the
program is played in the programmed order.
EN
16
TRACK STEP
1 1
PROGRAM 1 CD 1
Playing order
Repeat Steps
2, 3 and 6
4 to 6
2 to 6
Checking the programmed order
You can check your program before or after you start
playing.
Press CHECK.
Each time you press this button, the display shows the
disc and track number of each step in the programmed
order. (When a whole disc is programmed as one step,
"AL" appears instead of the track number.) After the
last step in the program, the display shows "END" and
returns to the original display.
Changing the programmed order
You can change your program before you start playing.
To
You need to
Erase a track or disc Press CHECK until the track or
disc you do not want appears in
the display, then press CLEAR.
Erase the last track or
Press CLEAR. Each time you
disc in the program
press the button, the last track or
disc will be cleared.
Add tracks or discs to the
Follow the programming
end of the program
procedure
Change the whole
Hold down CLEAR until "ALL
program completely CLEAR" appears in the display to
erase the whole program, then
create a new program following
the programming procedure.
Erasing the programs stored in memory
1
Press PROGRAM repeatedly in the stop mode
until the program number (PROGRAM 1, 2 or 3)
you want to erase appears in the display.
2
Hold down CLEAR until "ALL CLEAR" appears
in the display.