Securing Device - Siemens SIMATIC IPC647E Operating Instructions Manual

Installing and connecting the device
3.2 Mounting the device
3.2.2

Securing device

Dangerous voltage and fire hazard
Improper actions during installation and assembly may lead to personal injury and/or
substantial damage to equipment.
You should observe the installation and assembly notes under:
• Notes on mounting (Page 36)
• Notes on ambient and environmental conditions (Page 37)
Electrocution risk when control cabinet is open
When you open the control cabinet, there may be a dangerous voltage at certain areas or
components.
Touching these areas or components can cause death or serious bodily injury.
• Always disconnect the cabinet from the mains before opening it.
• Ensure that the power to the control cabinet cannot be turned on accidentally.
Risk of physical injury
The device is too heavy to be mounted exclusively with the 19-inch brackets of the front
panel.
The device may fall down, injure people and get damaged.
• Secure the device using additional measures. The mounting screws of the telescopic
• Use the brackets on the front panel to carry and lift the unit.
Mounting holes
Detailed information on the position of the mounting holes for angle brackets or telescopic
rails can be found here: Dimension drawing of the telescope rails (Page 157) and Technical
specifications of the telescopic rails (Page 153).
See also
Hardware accessories (Page 29)
46
WARNING
DANGER
CAUTION
rails may not protrude more than 5 mm into the device.
Operating Instructions, 11/2018, A5E45589180-AA
SIMATIC IPC647E