Parker PGMT-5200 Owner's Manual page 34

OPERATION
Hedge Topping (above head height)
Although it is possible to cut the top of a tall hedge
in this method, using a safe platform to raise
yourself level with the hedge top is preferred and
will result in a more attractive finish.
• Set the cutting head at 90 degrees.
• Twist the shaft to make the cutting head swing in
an arc across the top of the hedge.
•
Working in this position is particularly difficult.
Take regular breaks to avoid strain or injury.
Horizontal Cutting
The final stage is to shape the top of the hedge.
• Set the cutting head straight.
•
Make level arcs, so as to encourage the
trimmings on to the floor.
Do not attempt to cut a hedge higher than chest
height without using a safe platform.
WARNING! If working on a platform, do not attempt
to stretch or over reach. When cutting with the blade
set straight, tilt the cutting side of the blades toward
the hedge by approximately 0-10 degrees.
66
Hedge Trimmer Blade Maintenance
• Brush clean the cutting head thoroughly after
use. The blades must be cleaned of debris, sap
and moisture.
• Remove all traces of sap. Use a solvent cleaner to
spot clean any sap from the blades.
• Keep blades lubricated. Spray the blades with
a moisture dispersant lubricating oil. As with all
cutting means, blades will need regular
maintenance, whether for resharpening or
replacement.
THIS PAGE HAS INTENTIONALLY BEEN LEFT BLANK
67