Table of Contents
Advertisement
Seat the cards and tighten the thumbscrews. DO NOT use a Torx
4
screwdriver to tighten the thumbscrews.
For correct air circulation, filler panels must be installed in all unused card
W A R N I N G
slots. Correct air circulation keeps the instrument from overheating. Keep
any extra filler panels for future use.
To configure a multi-card module, use the master/expander trigger
5
cable included with the accessory kit of each HP 16533/34A card.
Starting with the top-most HP 16533/34A card, connect the ECL EXT
TRIG OUT to the ECL EXT TRIG IN of the card immediately below.
Repeat for all cards in the module.
Installation and Operator's Service
To configure the HP 16533/34A module
11–7
Advertisement
Table of Contents
