Table of Contents
Advertisement
Specifications and Characteristics
Supplemental Characteristics
Automatic Measurements: The following pulse parameter
measurements can be performed automatically.
•
Frequency
•
Rise time
•
+ pulse width
•
Period
•
Fall time
•
-pulse width
•
V p_p
•
Preshoot
•
V*
amplitude
•
Overshoot
(*gives difference between top and base voltages; only available over bus)
Grid Graticules can be displayed in background of waveform.
Setup Aids
Autoscale: Autoscales the vertical and horizontal ranges, offset, and
trigger level to display the input signals. Requires a frequency between
50 Hz and 250 MHz.
Presets Scales the vertical range, offset, and trigger level to
predetermined values for displaying ECL or TTL waveforms.
Calibration Vertical, trigger, delay, and all defaults. Calibration
factors stored in NV-RAM on the circuit board.
Probe Compensation Source External BNC supplies a square wave
approximately 0.0 mV to -800 mV into the open circuit at approximately
1000 Hz.
10–8
Advertisement
Table of Contents
