To inspect the module
Inspect the shipping container for damage.
1
If the shipping container or cushioning material is damaged, keep them until
you have checked the contents of the shipment and checked the instrument
mechanically and electrically.
Check the supplied accessories.
2
Inspect the product for physical damage.
3
Check the module and the supplied accessories for obvious physical or
mechanical defects. If you find any defects, contact your nearest
Hewlett-Packard Sales Office. Arrangements for repair or replacement are
made, at Hewlett-Packard's option, without waiting for a claim settlement.
To prepare the mainframe
Turn off the mainframe power before removing, replacing, or installing the
C A U T I O N
module.
Electrostatic discharge can damage electronic components. Use grounded
C A U T I O N
wrist straps and mats when performing any service to this module.
Turn off the mainframe power switch, then unplug the power cord.
1
Disconnect any input or output connections.
Plan your module configuration.
2
If you are installing a one-card module, use any available slot in the
mainframe, unless you also have an HP 16530/31 module in the mainframe.
If there is an HP 16530/31 module in the mainframe, the HP 16534 module
must be seated above the HP 16530/31 module.
If you are installing a multi-card module, use adjacent slots in the
mainframe. See illustration on next page for multi-card combinations.
Installation and Operator's Service
To inspect the module
11–3