Table of Contents
Advertisement
Installation and Operator's Service
To prepare the mainframe
Loosen the thumb screws.
3
Cards or filler panels below the slots intended for installation do not have to
be removed.
Starting from the top, loosen the thumb screws on filler panels and cards
that need to be moved.
Starting from the top, pull the cards and filler panels that need to be
4
moved halfway out.
All multi-card modules will be cabled together. Pull these cards out together
C A U T I O N
to prevent damage to the cables and connectors.
Remove the cards and filler panels.
5
Remove the cards or filler panels that are in the slots intended for the
module installation. Push all other cards into the card cage, but not
completely in. This is to get them out of the way for installing the module.
Some modules for the Logic Analysis System require calibration if you move
them to a different slot. For calibration information, refer to the Service
Guides for the individual modules.
11–4
Advertisement
Table of Contents
