Viking 1600-IP Series Product Manual page 15

The E-1600-55-IP is a universal emergency phone kit for
installing behind elevator panels, or an installation requiring a
custom panel. The finished panel should provide: (4) studs (#6
diameter minimum) for mounting plate, audio holes for speaker
and microphone, a momentary SPST push button switch and a
0.25" diameter mounting hole for the LED. Alternatively, the LED
can be cut off and the wires connected to a integral switch with
LED (often found in elevators).
Plastic Dust Cover (included)
Install prior to fastening the
faceplate to finished panel.
2.1
4.0
(4) 6-32 x 3/4" stainless steel flat
head, 5/64" hexdrive, screws
(included) for fastening dust cover
(4) Countersunk holes for
mounting the dust cover
2 Amp Relay
Output Contacts
Gray (N.C.)
Blue (COM.)
Yellow (N.O.)
Connect to momentary push
button switch with contact
rating of 50VDC/100mA min
Additional wire length
may be added if required
Red "Call Connected" LED with
included mounting hardware
(requires a 0.25" diameter hole)
Clear Spacer Red 5mm
Lens Round LED
Note: If you do not want to use the LED,
tuck it inside the unit. Do NOT cut it off.
E-1600-55-IP
2.0
Diameter
Black
Black
Red (LED
anode)
Black (LED
cathode)
Retaining
Ring
Optional Enhanced Weather Protection (EWP) Available:
The optional EWP products feature foam rubber gaskets and
boots, sealed connections, gel-filled butt connectors, as well
as urethane or thermal plastic potted circuit boards. See DOD
859.
Shipping Weight: .73 kg (1.6 lb)
Connections: (1) RJ45 10/100 Base-T, (5) gel-filled butt
connectors
Material: 0.062" thick (16 gauge) zinc plated steel
Note: When European CE compliance is required, mount in
a metal enclosure.
5.0
4.50
0.25
Diameter
1/16" thick foam gasket (included) for
accoustically sealing mic and speaker to back
of finished panel. Remove backing and adhere
gasket to front panel of the E-1600-55-IP,
centering over speaker and microphone holes
(as shown).
15
2.25 0.25 Typ.
1.76
3.625
Typ.
3.77
(4) 0.25 diameter
clearance holes for
mounting the unit
to the back side of
a finished panel.
(4) 0.25 diameter
holes (not used)
304 stainless steel speaker and
microphone protection screens
5.0
4.50