Viking 1600-IP Series Product Manual page 11

Dimensions: Overall - 127mm x 127 x
57mm (5.0" x 5.0" x 2.25")
Shipping Weight: 1 kg (2.12 lbs.)
Front Panel Material: 14 gauge Marine
grade 316 brushed stainless steel
Connections: Gel-filled butt connectors
"Old Work" Double Gang Rough-In Box*
(Example: Allied Molded 9312
box shown below, not included)
3.65"
*
2.25"
Wide
Deep
Min.
Min.
2.84"
Tall Min.
* CAUTION: Excessive wire length and/or using a rough-in box with inadequate depth can apply force to the circuit board causing physical damage.
Important: When warm air comes in contact with cold surfaces, such as outside walls and conduits, it causes condensation. To prevent condensation
from accumulating inside the E-1600-32-IP always bring conduit into the bottom of the unit. If this is not possible, drill a 1/4" diameter hole in the bottom
of the double gang box.
E-1600-32-IP
Optional Enhanced Weather Protection (EWP): The optional EWP products feature foam
rubber gaskets and boots, sealed connections, gel-filled butt connectors, as well as urethane
or thermal plastic potted circuit boards. See DOD 859.
Mounting in a Double Gang Rough-In Box (not included): Flush into walls, mounts to side
of wall studs, etc.
Note: For surface mount installations, use Model E-1600-30-IP with VE-5x5 surface
mount box.
Note: When mounting outside to rough or uneven surfaces (brick, stucco, etc.) apply a bead
of clear silicone caulking around the top edge and sides of faceplate.
Note: When European CE compliance is required, mount as shown, in a metal
enclosure.
(4) Optional Dry
Wall Screws
(not included)
BL-1 grade 2 black
Braille label included
11
Peel paper liner and adhere gasket
to back of panel, centering over
mounting holes. Caution: For rough
surfaces (ie: brick, stucco, etc.)
additional caulking may be required.
(4) T-10 Torx stainless steel,
flat head, security screws
and drive bit (included)
Call Connected Red LED
Marine grade 316 stainless
steel faceplate and push button
switches (sealed per IP67)
"Help" Push to Call Button
Laser Etched Graphics
PUSH FOR
2.20
HELP
VIKING
©
2.40