Viking 1600-IP Series Product Manual page 12

Dimensions: Overall - 127mm x 127 x 57mm (5.0" x 5.0" x
2.25"), Plastic Electrical Box - 102mm x 102mm x 54mm (4.0"
x 4.0" x 2.14")
Shipping Weight: 1 kg (2.12 lbs.)
Front Panel Material: 14 gauge Marine grade 316 brushed
stainless steel
Connections: Gel-filled butt connectors
Optional Enhanced Weather Protection (EWP) Available: The
optional EWP products feature foam rubber gaskets and boots,
sealed connections, gel-filled butt connectors, as well as urethane
or thermal plastic potted circuit boards, DOD# 859.
Note: When European CE compliance is required, mount in optional VE-5X5 metal enclosure.
Front View of
Plastic Rough-In
Box (included)
Wire knock out
(2) Standard flat head dry wall
(sheet rock) screws (not included)
(4) 6-32 X 3/4" Marine grade 316 stainless steel, flat head,
T-10 Torx security screws and drive bit (included)
5.22"
5.14"
Front View of Optional
2.25"
VE-5x5 (not included)
****Important: When warm air comes in contact with cold surfaces, such as outside walls and conduits, it causes condensation. To prevent condensation
from accumulating inside the E-1600-30-IP always bring conduit into the bottom of the unit. If this is not possible, drill a 1/4" diameter hole in the bottom
of the black plastic box.
E-1600-30-IP
4.0"
3.25" (4) 0.2 x 0.43 slots
for double gang box
Condensation
Drain Hole
**** 3/4"
Knockout
for conduit
Mounting with Plastic Rough-In Box (included): Flush into
walls, mounts to side of wall stud Mounting with Optional
VE-5x5: Surface mount to walls, single gang boxes, double
gang boxes, posts, or to a Viking VE-GNP Gooseneck
pedestal.
Important: The E-1600-30-IP will NOT mount to a standard
double gang box. If your applications requires a double gang
box, see model E-1600A-32-IP above.
*** Important: Optional Braille "Push for Help" label should
be adhered to the faceplate in ADA applications. Clean
surface with isopropyl alcohol, peel off backing and press
firmly to the front panel in location as shown.
Peel paper liner and adhere gasket to back
of panel, centering over mounting holes.
2.1"
Caution: For rough surfaces (ie: brick, stucco,
etc.) additional caulking may be required.
T E D
N E C
C O N
3.0" 3.3"
3.0"
Rear View of VE-5x5
(not included)
12
5.0"
Laser Etched Graphics
Call Connected Red LED
Marine grade 316 stainless
steel faceplate and push
button switches (sealed
per IP67)
Push to Call Button
Condensation Drain Hole
***Optional Braille Label
(2) 0.2 x 0.43 slots
for single gang box
(4) 0.38" diameter holes
Optional VE-5x5 Surface
Mount Box (left) with black
satin powder paint finish,
not included (DOD 424).
Optional VE-LIGHT kit can
be used to illuminate the
faceplate when used with a
VE-5x5 (DOD
WARNING: Do NOT use a
wet location box.
428).