XYZ Printing da Vinci Jr. WiFi Pro User Manual page 12

HOME AXES
"HOME AXES" moves the extruder to the lower left corner.
To home axes：
HOME AXES
ARE YOU SURE?
NO
YES
Select "YES" to proceed.
Z OFFSET
The user may use the Z OFFSET function to adjust the gap between the printing nozzle and the printing bed.
When adjusting the gap, use
[ ^ ]
Z OFFSET 0.91 mm
[ v ]
[ OK ] WHEN FINISH
After adjusting, press "OK" to exit.
Note:
1
The product has been tested and adjusted with precision at factory. We suggest that
you write down the default Z OFFSET value before performing adjustment.
The recommended distance between the nozzle and print bed(with bed tape securely
2
fastened) is 0.3mm. This should allow two sheets of copy paper to be drawn out
smoothly but six sheets of copy paper cannot be passed.
JOG MODE
"JOG MODE" is used to manually move the extruder and the print bed.
Before you carry out this function, move the extruder module back to its original position (HOME AXIS).
How to move the extruder:
JOG MODE
X-AXIS
Y-AXIS
Z-AXIS
Select the direction of the module or the print bed
1
to be moved.
Note: "X-AXIS": left and right movement of the
extruder module, "Y-AXIS": front and back
movement of the print bed, "Z-AXIS": up and
down movement of the extruder module.
HOME AXES
COMPLETED
[ OK ] TO RETURN
and keys to increase or decrease it (the minimum adjustment scale is 0.05mm).
UTILITIES
Z-AXIS [ OK ] >> EXIT
[ － ] [ 0.1mm ] [ ＋ ]
1mm
10mm
2
Select desired increment of travel with
and buttons, and press
button for desired direction to move the extruder.
da Vinci
Jr. WiFi Pro
or
P 12