XYZ Printing da Vinci Jr. WiFi Pro User Manual page 11

BUILD FROM CARD
1 sample models are built into the printer. You may begin your first 3D prints with the samples.
To print a sample ：
BUILD (SD CARD)
SAMPLE
1 Select a sample
to print.
LOAD FILAMENT
Enable the LOAD FILAMENT function on the control panel...
Jr. WiFi Pro
BUILD FROM CARD
UTILITIES
SETTINGS
1 Select "UTILITIES" > "CHANGE SPOOL" > "LOAD FILAMENT" > "USE XYZPRINTING SPOOL?" > "YES".
LOAD FILAMENT
EXTRUDER HEATING
TEMPERATURE 210 °C
PLEASE WAIT
2
Insert the filament right into the feed hole. The printer will load the filament automatically.
After loading, select "OK" to continue. The printer will warm up to the operating
temperature and load the filament.
UNLOAD FILAMENT
Enable the UNLOAD FILAMENT function on the control panel...
Jr. WiFi Pro
BUILD FROM CARD
UTILITIES
SETTINGS
1
Select "UTILITIES" > "CHANGE SPOOL" > "UNLOAD FILAMENT".
UNLOAD FILAMENT
EXTRUDER HEATING
TEMPERATURE 210 °C
PLEASE WAIT
2
Wait for the extruder to heat up and unload filament. Press "OK" and pull out the filament.
Note: Always implement the "UNLOAD FILAMENT" function when replacing the Spool in order to ensure proper
removal of the filament. Cutting filament too closely to the Extruder Module may result in residual filament
blocking and causing damage to your Extruder Module.
2 Put the bed tape
on the print bed.
*Please refer to P.24 for third party filaments.
UTILITIES
CHANGE SPOOL
HOME AXES
Z OFFSET
LOADING
PLEASE WAIT
UTILITIES
CHANGE SPOOL
HOME AXES
Z OFFSET
UNLOADING
PLEASE WAIT
[ OK ] TO RETURN
UTILITIES
START BUILDING
SAMPLE
NO
YES
3 Select "YES" to
start printing.
CHANGE SPOOL
LOAD FILAMENT
UNLOAD FILAMENT
CHANGE SPOOL
LOAD FILAMENT
UNLOAD FILAMENT
UNLOAD
COMPLETED
[ OK ] TO FINISH
da Vinci
Jr. WiFi Pro
Remove the printed object when
4
the printing has finished and the
print bed has descended.The bed
tape is reusable and it can be
replaced when it's worn.
USE XYZPRINTING
SPOOL?
YES
NO
CHECK FILAMENT
OUT FROM NOZZLE
[ ] TO RETRY
＜
[ OK ] TO RETURN
3
Confirm that the filament is flowing out
from the extruder; If the filament flows
out, press "OK" to exit.
P 11