4 Application
4.1 Creating a CEREC Guide 2
14
4
Application
Creating a CEREC Guide 2
4.1
4.1.1
Optical impression
1. Scan the situation in the mouth either intraorally or using a model.
The following applies at least to all areas which are intended to later
serve as a support for the CEREC Guide 2. The surface scan is
also used for the overlay of the x-ray volume.
NOTE
Note that the drilling template cannot be bigger than the scanned
area.
Avoid holes in the scan. Otherwise, no locating surface for the
CEREC Guide 2 can be determined at these points.
2. Design a restoration at the planned implant position. Mark the
emergence profile of the tooth on the gingiva in manual entry mode.
3. Export the data record using in *.SSI format.
Dentsply Sirona
Operating Instructions CEREC Guide 2