Throttle Cable - Arctic Cat 2018 ZR 200 Service Manual

Throttle Cable

REMOVING AND INSPECTING
1. Compress the throttle lever to the WOT position;
then using a small pliers, remove the throttle cable
from the lever.
2. Remove the C-clip securing the throttle cable to the
control; then remove the throttle cable.
3. Cut the cable ties securing the throttle cable to the
steering post.
 NOTE: Note the location of the cable tie for assem-
bly.
4. Rotate the throttle cable lever of the governor control
arm to the wide-open position and route the cable
end out of the arm; then loosen the throttle cable jam
nuts and remove the throttle cable.
ZR-164
5. Inspect the throttle cable for damage or fraying.
INSTALLING
1. Route the throttle cable through the slot in the throt-
tle control and insert the cable end into the throttle
control. Secure the cable with a C-clip.
2. Seat the drum into its lever recess; then secure the
lever with a pin and push nut.
3. Place the throttle cable into the throttle cable bracket
and secure with jam nuts.
4. Slide the end of the throttle cable into the throttle
cable lever.
5. Secure the throttle cable to the steering post with a
cable tie; then install the handlebar pad.
6. Open and close the throttle lever to make sure of no
binding or sticking.
ADJUSTING
NOTE: Ensure that the throttle cable is properly

seated in the throttle control housing.
1. Verify when releasing the throttle lever that the
round switch in the control housing is compressed. If
the switch is not compressed the engine will shut
down when the throttle lever is released.
ZR-089A
ZR-090
2. If the throttle cable needs to be adjusted, locate the
throttle cable in-line adjuster next to the steering
post; then adjust the in-line adjuster until the gover-
nor arm (A) starts to move.
ZR-090A
3. Tighten nut against the in-line adjuster and cover the
adjuster with rubber boot.
33