Throttle Cable - Arctic Cat Sno Pro 120 2011 Service Manual

3. Secure all wires and hoses with cable ties.

Throttle Cable

REMOVING
1. Loosen the throttle cable adjuster at the bracket.
2. Remove the throttle cable from the pulley on the
throttle body lever shaft.
3. On the 500 cc, remove the E-clip securing the oil-
injection cable to the oil-injection pump control arm.
Account for a washer.
4. On the 500 cc, loosen the oil-injection cable jam
nuts.
5. On the other models, remove the handlebar pad and
the console (if applicable).
6. Remove the cable ties securing the throttle cable.
7. Remove the throttle cable ends from the throttle
lever and from the throttle control housing.
 NOTE: Some EFI models are equipped with a con-
trol rod activated oil pump. If it must be removed, the
rod simply snaps off and on at the control arm.
INSTALLING/ADJUSTING
1. Install the throttle cable into the throttle switch
assembly making sure the cable snaps into place.
2. Install the throttle cable end on the throttle lever.
3. Route the throttle cable from the throttle switch
assembly to the throttle body assembly and oil-injec-
tion pump; avoid any sharp bends or moving compo-
nents.
4-28
4. Attach the throttle cable to the pulley on the throttle
body shaft.
5. On the 500 cc, install the oil-injection cable adjuster
on the oil-injection pump; secure with the jam nuts.
6. On the 500 cc, install the oil-injection cable on the
control arm; secure with a washer and E-clip.
7. Secure the throttle cable to the handlebar and steer-
ing post with cable ties.
8. On the other models, install the handlebar pad and
the console (if applicable).
9. Adjust the throttle cable tension by turning the jam
nuts in the appropriate direction until 0.030-0.060 in.
free-play exists in the throttle lever and the butterfly
completely opens and closes. Tighten the jam nuts
securely.
Compress the throttle control lever to ensure free
movement. If the throttle cable sticks or binds, correct
the problem before starting the engine.
10. Synchronize the oil-injection pump.
Manual
Table of Contents
CAUTION
741-518A