Throttle Cable - Arctic Cat Sno Pro 120 2013 Service Manual

Throttle Cable

The correct throttle cable adjustment is when (with the
engine OFF) the carburetor throttle is completely open
(against its limit) while the throttle lever lightly contacts
the handlebar grip. The throttle arm on the carburetor
should also contact the speed control screw when the
throttle lever is released.
1. To adjust the throttle cable, loosen the throttle
cable jam nuts.
! WARNING
Do not attempt to adjust the throttle cable with the
engine running. Personal injury could result.
2. Pull all slack from the throttle cable wire and exert
slight tension on the wire.
3. Tighten the throttle cable jam nuts.
! WARNING
DO NOT operate the snowmobile when any compo-
nent in the throttle system is damaged, frayed, kinked,
worn, or improperly adjusted. If the snowmobile is
operated when the throttle system is not functioning
properly, personal injury could result.
30
Speed Control Screw
IO110B
The maximum speed of the snowmobile can be reduced
by adjusting the speed control screw.
To reduce the maximum speed, rotate the speed control
screw clockwise. DO NOT EVER INCREASE THE
MAXIMUM SPEED BEYOND THE ORIGINAL 8
MPH MAXIMUM.
Throttle Cable
REMOVING AND INSPECTING
1. Remove the C-clip securing the lever pin in the
throttle lever; then remove the pin and the lever.
0744-922
2. Disconnect the throttle cable from the lever; then
slide the cable out of the lever.
0744-949
A979
A980