Installing Skid Frame - Arctic Cat 2018 ZR 200 Service Manual

2. Inspect the wear strip for wear. The wear strip must
be 0.42'' thick or thicker. If the wear strip measure-
ment is less than specified, replacement of both wear
strips is necessary.
INSTALLING
1. Install the rear axle housing and adjuster bushing;
then secure with cap screws and lock nuts. Tighten to
20 ft-lb.
2. Install the rear idler wheel and secure the rear idler
wheel with a cap screw (coated with blue Loctite
#243) and washer. Tighten to 20 ft-lb.
3. Secure the rear suspension arm support bracket to the
slide rail with cap screws and lock nuts. Tighten to
20 ft-lb.
SNO-975
4. Secure the rear arm to the support bracket with the
cap screw. Tighten to 20 ft-lb.
5. Secure the cross-brace axle to the slide rail with the
cap screw (threads coated with blue Loctite #243).
Tighten to 20 ft-lb.
SNO-974
6. Place the shock pad into position and secure with a
solid rivet and push nut.
54
SNO-995
7. Place the end cap onto the rail and secure with the
cap screw, washers, and lock nut. Tighten to 80 in.-
lb.

Installing Skid Frame

1. Pull the track away from the tunnel and spread open;
then place the skid frame into the track.
2. Position the skid frame into the tunnel and align the
four mounting locations with the appropriate mount-
ing holes in the tunnel. Secure using the existing cap
screws (coated with blue Loctite #243). Thread the
cap screws in only half way. DO NOT TIGHTEN AT
THIS TIME.
3. Securely tighten all mounting hardware to 20 ft-lb.
4. Check track tension; adjust as necessary.