Storage - Elcometer CG30 Operating Instructions Manual

9.2.4 Installing NDT Link
NDT Link comes on a CD-ROM with an automatic installer program. Place the CD in your
computer's CD tray and close the door. Open the CD-ROM by double clicking on the My Computer
ICON, then double click on the CD. Finally, double click on the SETUP icon to begin the installation.
Refer to the help section in NDT Link software for the complete operating manual, setup, and
operation.
9.3 TRANSFERRING DATA
Model CG50
After taking a measurement, press the SEND key to send the measurement to the computer.
Model CG50DL
TRANSFERRING ONE BATCH
1. Connect the gauge to a computer and start the data transfer software - see "Transferring
readings to a computer - CG50/CG50DL only" on page 17.
2. Press ON/OFF key to switch on the gauge.
3. Press MEM key to activate the data logging functions and settings.
4. Press SEND key to enter batch setup.
5. Press UP / DOWN arrow keys to scroll to the batch that is to be sent to the computer.
6. Press SEND key once again to select the batch. The display will flash FILE F-05 (or the batch
selected).
7. Press UP / DOWN arrow keys to scroll to LISt F-05 (or the batch selected) flashing on the
display.
8. Press the SEND key to send readings to the computer.
The display will show buSY during data transfer.
Wait until all the data has been transferred.
9. Press the MEM key to exit the data logging functions.
TRANSFERRING ALL BATCHES
1. Connect the gauge to a computer and start the data transfer software - see "Transferring
readings to a computer - CG50/CG50DL only" on page 17.
2. Press ON/OFF key to switch on the gauge.
3. Press MEM key to activate the data logging functions and settings.
4. Press UP / DOWN arrow keys to scroll to SEnd ALL flashing on the display.
5. Press the SEND key to send readings to the computer.
The display will show buSY during data transfer.
Wait until all the data has been transferred.
6. Press the MEM key to exit the data logging functions.
Press the MEM key, at any time, to exit the data logging functions.

10 STORAGE

Your gauge has a Liquid Crystal Display. If the display is heated above 50°C (120°F) it
may be damaged. This can happen if the gauge is left in a car parked in strong sunlight.
Always store the gauge in its case when it is not being used.
If the gauge is to remain unused for long periods of time, remove the batteries and store them
separately. This will prevent damage to the gauge in the event of malfunction of the batteries.
18