The Keypad - Elcometer CG30 Operating Instructions Manual

2 THE KEYPAD

MODEL CG30 (6 BUTTONS) AND CG50 (9 BUTTONS)
Press to switch the gauge on or off.
When switching off, the gauge retains all of its settings.
If the gauge is idle for 5 minutes, it will switch itself off.
Press to zero the gauge.
PRB
See "Transducer - Zeroing" on page 8.
0
Press to adjust calibration.
See "Calibration" on page 9.
Press to change units (metric/imperial)
IN
IN
MM
MM
a) Increases values on the display
(press and hold to change values quickly).
b) Switches SCAN measurement on and off.
See "Scan mode" on page 12.
a) Decreases values on the display
(press and hold to change values quickly).
b) Switches the display backlight between three settings; on, off and auto. See "Backlight"
on page 15.
a) Press and hold when switching the gauge on to switch the audible beeper on or off.
b) Press to toggle the alarm on or off, and to adjust the nominal thickness value. See
"Alarm - CG50 and CG50DL only" on page 13.
Press to toggle the DIFFERENTIAL mode on or off, and to adjust the nominal thickness
value.
See "Differential Mode - CG50 and CG50DL only" on page 13.
Press to send the displayed thickness measurement to an external storage device via the
RS232 port.
See "Transferring readings to a computer - CG50/CG50DL only" on page 17.
MODEL CG50DL
Press to switch the gauge on or off.
When switching off, the gauge retains all of its settings.
If the gauge is idle for 5 minutes, it will switch itself off.
Press to zero the gauge.
PRB
See "Transducer - Zeroing" on page 8.
0
Press to adjust calibration.
See "Calibration" on page 9.
Press to adjust the features and settings of the gauge (alarm, scan, units, backlight, and beeper).
MODE
5
CG30
CG50
CG30
CG50
CG30
CG50
CG30
CG50
CG30
CG50
CG30
CG50
CG50
CG50
CG50