Extron electronics RCP 101 D Setup Manual page 5

Configuration
SMP Web Page
The RCP 101 D can be configured from the SMP web page. Use a PC connected to the same subnet as the SMP.
Open a Web browser and enter the IP address of the SMP (see the User Guide for your SMP model).
1.
You may need to log on as
The SMP Web page opens.
To confirm that the RCP 101 is connected to the SMP, click
2.
Unit Identification
When the RCP 101 D is not connected, or not detected by the SMP, the following information is displayed:
When the RCP 101 D is detected by the SMP, the following information is displayed:
To save a recording to the USB device inserted into the RCP 101 D, click
3.
Recording Media Selection
and
Recording
From the
RCP USB
appropriate, select
1 1
3 3
5 5
SMP Web Page
Figure 6.
To configure Front Panel Lockout, click
4.
The options shown in figure 8 are available only when the RCP 101 D is detected. By default:
Front Panel Lockout (Executive Mode) is disabled (see
•
Beep when button is pressed
•
Beep when alarm is triggered
•
Select or deselect the appropriate checkbox to enable or disable those options.
admin
.
( 3 ).
4
( ).
Destination drop-down menu, or the
.
4 4
Configuration
is enabled.
is disabled.
Configuration
(figure 8,
Configuration
Secondary Recording Destination
2 2
System Settings
( 1 ), ( 2
Front Panel Lockout (Executive Mode)
Product Category
System Settings
1 ), ( 2
1 System Settings
( ),
drop-down menu, as
Executive Mode
), and ( 5
on page 1).
), and
2
( ),
).
5