Altendorf WA 80 Operator's Manual page 41

Saw blade with stepless cut width RAPIDO
Replace scorer saw blades for RAPIDO
Take the adjuster unit off the machine; the clamping
screw may have to be released since a tightened
clamping screw can cause the adjuster unit to jam
on the shaft!
Dismantling:
With hexagonal key:
– Release clamping screw (1) appr. 3-4 turns, ro-
tate spindle (2) clockwise until the flange (3)
can be pulled away from holder (4)
With Innentorx key:
– Unscrew screws (5)
– Remove circular saw blade (6)
– Fully clean flange (3) and screws (5). The run-
ning and flange surfaces must be clean and
dust free.
– Fit a new circular saw blade, note direction of
rotation and arbor image when fitting: The cir-
cular saw blade (6) lies flat on the flange (3) and
the protrusion on the circular saw blade points
to the contact surface
– Screw in screws (5) and tighten to a torque of
8,6Nm
– Proceed in the same way with the other half of
the adjuster unit
© ALTENDORF 2007
Assembly:
Do not oil or grease!
– Clamping screw (1) is released
– Fit the flange (3) vertically on to the holder (4)
so that the spindle (2) engages in the threaded
hole (7)
– Use the hexagonal key to turn the spindle (2) in
a counterclockwise direction. The flange (3) will
be pulled into the holder (4) no additional force
may be used here
– Continue to turn spindle (2) until the two halves
of the circular saw blade are lying against each
other
– Install the adjuster unit on the machine
– Setting the cutting width, see above
– Only turn clamping screw (1) slightly
38