Table of Contents
Advertisement
Saw blade recommendation
–
When selecting tools ensure that no blunt or
damaged tools are fitted.
–
The highest permitted speed specified on the
tool may not be exceeded.
–
HS-Sägeblätter dürfen nicht verwendet wer-
den!
–
The tools must have a hole diameter of 30 mm
and driving pin holes of 10 mm Ø in a 60 mm Ø
semicircle.
–
The correct choice of saw blade depending on
the material to be handled and the strength of
the material is vitally important, along with the
correct cutting speed for clean cutting and low
stress on the operator. A selection of saw
blades for the Altendorf sliding table saw is
shown in the table (p.29). This table makes no
claims to be complete. Since the figures for the
cutting speed cover large ranges in some cases
it is vital to determine the best cutting speed for
optimum cutting results by trial and error!
© ALTENDORF 2007
Scorer saw blade
Scorer saw blade: D=120 mm, 24 teeth, flat tooth,
arbor diameter 22 mm
Riving knife
The riving knives supplied are suitable in size for
the range of saw blade diameters specified in the
table. The corresponding range is specified on the
bottom end of the relevant riving knife.
The thickness of the riving knife is however only
correct where the blades concerned are commer-
cially available carbide-tipped saw blades. For CV
saw blades other riving knives are required.
30
Hide quick links:
Advertisement
Table of Contents
