Electrical Connection - Altendorf WA 80 Operator's Manual

Electrical connection

5.5 Electrical connection
All work on the electrical system, including
connection to the power network, may only be
performed by an electrical specialist. When
working on the electrical equipment the ma-
chine must be disconnected from the mains
power.
The electrical connections are made in the main
switch housing which is on the front of the machine
stand. The terminals for the leads are marked L1,
L2, L3, N and PE, the terminal for the floating con-
tact is marked POT. The lead is 2.5 mm2 in cross
section and 25A fuses are to be provided on the op-
erating side.
If the machine is connected via a movable lead, a
rubber tube lead (lead designation H07RN-F) must
be used. Plug connector required: Round plug con-
nector according to DIN 49463.
After the lead is connected the direction of rota-
tion of the main saw motor is to be checked by
Fig. 5-1: Main switch
briefly turning the machine on and if necessary
corrected by swapping two external leads in the
mains connection box.
Note the arrow indicating direction of rotation
on the saw blade cover!
Fig. 5-2: Main switch, POT-contakt
© ALTENDORF 2007 20