Adjustment of the saw blade width
7.9.2 Adjustment of the saw blade width
Standard saw blade
–
Use spacers to bring the scorer saw blade to
the width which is 0.1 mm greater than the
width of the main saw blade
–
Set the alignment of the scorer to the main saw
first on the table plate side
–
Test cut
–
Set the alignment on the left side by adding or
removing intermediate rings
© ALTENDORF 2007
Saw blade with stepless cut width RAPIDO
Fig. 7-7: Release the clamping screw
Fig. 7-8: Turn the spindle
Only use the tool supplied for adjustment work!
–
Release the clamping screw, appr. 2 turns
–
Turn the spindle until the desired dimension is
reached. (1 turn = 0.5 mm)
–
Tighten the clamping screw
–
Test cut, if necessary correct the cutting width
again as described above.
37