Scorer Saw - Altendorf WA 80 Operator's Manual

Scorer saw

7.9 Scorer saw
The Altendorf scorer saw was developed to enable
boards coated on both sides to be cut on the under-
side without damage.
The material is only cut into by around 1-2 mm by
the scorer or the underside and then separated
from the main sheet. The blade of the scorer must
be precisely aligned to the main blade and set to
the corresponding width.
– Two-piece scorer blades are to be recommend-
ed which are adjusted to the required blade
strength by insertion of distance pieces. The
cutting widths of the scorer blades should be at
least. 1/10 mm wider than those of the main
blades, i.e., 5/100 mm to each side. In addition
the two scorer blades should feature driver pins
and the width should be printed on the spacers.
– The scorer saw can only be started after the
main saw has reached its operating speed (af-
ter around 5 seconds.), by pressing the white
button I which is also located in the panel and
identified by the symbol for the scorer saw.
© ALTENDORF 2007
Fig. 7-6: Scorer adjustment
Lateral adjusment
Adjustment
Height and lateral adjustments are made mechani-
cally and can be performed when the machine is
running.
35
Height adjustment