Operational safety details
–
Wobble units or wobble cutting devices are not
allowed to be used.
–
Only use grooving tools with a maximum width
of 15 mm that are permitted for manual feeding.
This is the case when tools have the inscription
"MAN".
–
The sound pressure level at the workplace
generally exceeds 85 dB(A). For this reason,
wear hearing protection when working.
–
The sawdust generated during cutting impairs
visibility and is, in part, detrimental to health.
The machine must therefore be connected to a
chip extraction system with both extraction
sockets. The minimum air speed at the lower
extraction socket must be at least 20 m/s.
When the machine is switched on, the
extraction system must switch on at the same
time.
–
Only qualified electricians are permitted to work
on the electrical equipment of the machine.
–
Regular cleaning of the machine and, in
particular, the main table, sliding table and
guides (e.g. rip fence) is an important safety
factor. Before starting this work, make sure that
the
machine
cannot
unintentionally.
© ALTENDORF 2007
be
switched
on
7