Altendorf WA 80 Operator's Manual page 45

Trouble
Fault Casuse
The finished dimen- Scale for cutting width display
sion of the cut work- incorrectly adjusted
piece does not
correspond to the
cutting width set at
the crosscut fence
Sliding table has Lower rollers incorrectly
sideways play adjusted
Sliding table in end Lower rollers incorrectly
positions higher adjusted
than machine table
Saw blade burns on Insufficient free cutting space
the sliding table side of sliding table
Free cut adjustment of rip
fence too great
Saw blade burns on Insufficient free cut of the rip
the rip fence side fence
Saw blade burns on Incorrect free cut adjustment Adjust free cuts
both sides
Workpiece sticks
Operating error
Workpiece has burn Blunt saw blade
marks
Saw blade has too many
teeth
Sägeblatt hat zu viele Zähne Change saw blade
Incorrect free cut
Tears instead of Scorer not aligned with main
scorer saw
Scorer blade too narrow
Workpiece lifts when Scorer blade blunt
cutting with the
scorer
Cutting height too small
E01 End switch ES_Min1 reached
E03 End switch ES_Max reached
E04 Emergency switch actuated
E07 Error positioning drive
quick blinking (4Hz) Overtemperature mainsaw
in the ON-switch motor
slow blinking (1Hz) Error brake: Mains relay is
in the ON-switch not in 0-position
LED rotation speed No input signal
blinking
© ALTENDORF 2007
Remedy
Readjust scale. Cut workpiece at rip fence, meas-
ure cutting width and move measuring scale so that
the measured cutting width is shown on the edge of
the straightedge
Adjust lower rollers
Adjust lower rollers
Adjust free cut
Adjust rip fence
Adjust free cut
Place wedge in cut or use thicker riving knife
Feed workpiece left or right on fence. When cut-
ting with the sliding table do not fed the workpiece
at the rip fence
Changing the saw blade
Increase speed of feed
Adjust free cut
Adjust free cuts; the free cut should be almost „0"
Set saw width blade
Replace
Set blade higher
Control emergency switches/door/cover
42