Saw blade change
7.9.1
Saw blade change
The description of saw blade change only ap-
plies to divided scorer saw blades and also to
saw blades with stepless cutting width adjust-
ment. Only use saw blades with a diameter of
120 mm and 22 mm arbor diameter!
Switch off the drives
–
Move scorer saw into its highest position
–
Move sliding table in cutting direction
–
Unlock the lock in the middle of the saw
–
blade by pressing the spherical button on
the center carriage
Move the sliding table into its end position
–
in the cutting direction
Raise lower protective hood (orange hood)
–
–
Die Befestigungsmutter durch Linksdrehen lö-
sen
Before fitting the new scorer saw blade
–
clean off any sawdust adhering to the two
flanges
Place the saw blade and front flange on the
–
saw drive shaft and tighten the nut in a
clockwise direction
© ALTENDORF 2007
In addition the following points should be noted
when using RAPIDO scorer saw blades with step-
less cutting width adjustment :
–
Ignoring the operating instructions reduces op-
erational safety impermissibly and leads to ex-
clusion of liability
–
max. speed =8200 1/Min
–
Permitted cutting width 2.8 - 3.8 mm
–
The adjuster unit must be unpacked and
packed with particular care, danger of injury!
–
Only store the adjuster unit in its original pack-
ing!
–
The scorer saw blade must be installed outside
the machine
–
All connecting elements must be installed
–
If the connecting elements are lost or damaged
only original spare parts may be used as re-
placements!
36