Machine Configuration - Altendorf WA 80 Operator's Manual

Machine configuration

6 Machine configuration
The basic machine settings are made in the works
during final assembly. Dismantling various mod-
ules, transport and assembly at the installation site
can mean that it is necessary to correct the ma-
chine settings. The machine parts to be checked
are described below.
Checking the lower rollers
The lower rollers must move smoothly at the start
and end of the running surface over the starting an-
gle. They should be set so that they can be stopped
manually by exerting a perceptible force and slide
freely while the sliding table is moved.
Adjustment of the lower rollers
The lower rollers are supported eccentrically and
adjustable. If they are set too tight the sliding table
is hard to move
Checking the table plate
Place a straightedge on the sliding table, carriage in
mid position. Move carriage backwards and for-
.
wards, Table plate must lie about 1/10mm lower
Adjustment of the table plate
Loosen the locknuts on the 4 fixed bolts, Adjust the
table plate, tighten the nuts. Then lay the straight-
edge in parallel to the sliding table on the table
plate.
© ALTENDORF 2007 23