Resetting Data To Zero - Wega Polaris EPU Instruction Manual

13.5 WATER SOFTENER REGENERATION programming
Programming of the automatic warning of water softener regeneration:
1) Enter programming until showing on the display;
2) set the amount of water (steps of 50 litres) with the keys
3) to move to the subsequent programming press the key MODE
When the machine reaches 90% of the value set on the display a signal appears for 5 seconds. When the
machine reaches 100% of the value set on the display a blinking signal appears.
i
To eliminate the blinking signal and reset the count of the litres of water to zero, with the programming
switch in the ON position press the
until the display shows the message " clock set up ".
The regeneration control is bypassed by setting a value equal to 00 litres.
13.7 LANGUAGE programming
Programming of the language displayed:
1) Enter programming until showing on the display;
2) set the language with the keys
3) to move to the subsequent programming press the key MODE
i
In English it is possible to choose between degrees Celsius (°C) and Fahrenheit (°F)
13.8 DOSERS alarm
Control of the dispensers alarm. The 3 values displayed correspond to the
delivery groups.
R
14. esetting data to zero
14.1 Resetting of dosers alarm
1) Place the programming switch in the ON position ;
2) with the key MODE
3) to start resetting press the key
4) to confirm resetting press the key
5) upon completion turn the programming
22
DISPLAY - AVANTGARDE
;
scroll the menu until the dispenser alarms;
;
for 3 seconds;
switch back to
;
.
4 keys of the left push button panel simultaneously
.
OFF.
reg. softener
000000
language
English
doser alarm
000 000 000 000
doser alarm
021 007 000
reset counting ?
press + 3 sec.
doser alarm
000 000 000