Chapter 2: Setting And Unsetting; Introduction; Setting And Unsetting From The Control Unit; Setting From The Control Unit - Eaton i-on Compact Administration And User Manual

Chapter 2: Setting and Unsetting

Introduction

Readying the system to start an alarm when someone moves into a
protected area is called "setting" the system. Disarming the system so that
people can move freely is called "unsetting" the system.
You can set and unset your system using a variety of different methods,
depending on how the installer has configured your system. This chapter
explains typical methods used.
Note: The control unit can monitor some detectors continuously,
irrespective of whether the system is set or unset. For example:
 Fire and smoke detectors, flood sensors, Hold Up Alarm buttons or
emergency exits.
 Monitors for machinery (for example freezers) or other type of
"technical alarm".

Setting and unsetting from the control unit

This section explains how to set and unset your system from the keypad on
the control unit. If you are using a one-way radio keypad (which has no
display), please refer to page 14.
Note: Figure 2 on page 3 gives an overview of each key.

Setting from the control unit

With the standby screen displayed:
1. Enter your access code or present your proximity tag to the keypad. If
you enter your access code, the display shows a "*" for each
completed digit:


Page 7