Configuring Ntp Server - HIKVISION DS-7100NI-K1 Series User Manual

2) In the NVR Domain Name text field, enter the domain obtained from the
NO-IP website (www.no-ip.com).
3) Enter the User Name and Password registered in the NO-IP website.
Click Apply to save the settings.
After setting all the required parameters for the DDNS, you can view the
connecting status of the device by checking the Status information.

Configuring NTP Server

Purpose:
Ensure the network connection of the PC (running FTP server) and the device is valid
and correct. Run the FTP server on the PC and copy the firmware into the
corresponding directory of your PC.
Refer to the user manual of the FTP server to set the FTP server on your PC and put
the firmware file into the directory as required.
Go to Menu > Configuration > Network.
Select NTP to enter the NTP Settings interface, as shown in Figure 9-10.
Check Enable NTP to enable this feature.
Configure the following NTP settings:
Interval: Time interval between the two synchronizing actions with NTP server. The
unit is minute.
NTP Server: IP address of NTP server.
Network Video Recorder User Manual
Figure 1. 1 NO-IP Settings Interface
NTP Settings Interface
112