Sony DCR-TRV16 Operating Instructions Manual page 52

Using the fader function
(1)
When fading in [a]
In the standby mode, press FADER until the desired fader indicator flashes.
When fading out [b]
In the recording mode, press FADER until the desired fader indicator flashes.
The indicator changes as follows:
_ FADER -+ M. FADER -+ BOUNCE -+ MONOTONE -+ OVERLAP •
no indicator ÷ DOT • WIPE
(2)
The last selected fader mode is indicated first of all.
Press START/STOP. The fader indicator stops flashing, then light up.
After fade in/out ends, your camcorder automatically returns to the normal
mode.
START/STOP
To cancel the fader function
Before pressing START/STOP, press FADER until tile indicator disappears.
Note
You carmot use tbe following functions wbile using tim fader function. Also, you cannot
use the fader function while using the following functions:
Digital effect
Super NightSbot
Color Slow Shutter
Recording still images on a "Memory Stick" in the tape recording or standby mode
(except DCR-TRVI 6}
Tape Photo recording
Interval recording
Frame recording
When you set the POWER switch to MEMORY (except DCR-TRV16)
You cannot use the fader function.
When the OVERLAP, WIPE, or DOT indicator appear in the standby mode
Your can]corder automatically stores tile image recorded on a tape. While tim image is
being stored, the indicators flash fast, and the playback picture disappears. At tbis
stage, tile picture may not be recorded clearly, depending on the tape condition.
52